![]() ![]() Requirements for columns with tie reinforcement are given in ACI 318 Sections 10.7.6 and 25.7.2, and standard hook dimensions for ties are given in ACI Section 25.3.2. These lap splices also must be located away from the ends of the column where spalling of the concrete shell surrounding the transverse reinforcement is likely to occur due to a seismic event (ACI 318 Section 18.7.4.3). The type of lap splice that must be used depends on the stress in the longitudinal bars due to the factored load combinations (see ACI 318 Section 10.7.5.2).įor columns that are part of special moment frames in buildings assigned to SDC D, E, or F, lap splices must be tension lap splices and located within the center half of the column length. ![]() Similar tables can be created for other tie bar sizes and circular longitudinal bar arrangements.įor columns in ordinary moment frames in buildings assigned to Seismic Design Category (SDC) A or B, or in intermediate moment frames in buildings assigned to SDC C, lap splices of the longitudinal bars are permitted to occur immediately above the top of the slab, which is the preferred location for ease of construction ( Figure 2). The column face dimensions have been rounded to the nearest inch. To facilitate the selection of the longitudinal bars, Table 2 contains the minimum face dimension of rectangular tied columns with normal lap splices based on the minimum spacing requirements assuming 1.5-inch clear cover to #4 ties. Minimum face dimension (inches) of rectangular tied columns with normal lap splices. ElixirLS - sgf-parsing client: couldn't create connection to server.Table 2. Message: Pending response rejected since connection got disposed Runtime terminating during boot ()Ĭrash dump is being written to: erl_ Code navigation to Elixir modules disabled. Elixir sources not found (checking in /home/build/elixir). Please reinstall or rebuild OTP with approperiate flags. Language features for erlang modules will run in limited mode. OTP compiled without EEP48 documentation chunks. Running on elixir "1.14.4 (compiled with Erlang/OTP 26)" on OTP "26" ElixirLS built with elixir "1.12.3" on OTP "22" This is what I get in the Output tab: Started ElixirLS v0.13.0 Hi, I am trying to get ElixerLS setup in VSCode but getting an error. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |